Registers a function to be called when a slave device receives a transmission from a master. Please refer to the specific processor documentation to make sure the desired mode is supported. Some processors also support 10000 (low speed mode), 1000000 (fast mode plus) and 3400000 (high speed mode). Accepted values are 100000 (standard mode) and 400000 (fast mode). This function modifies the clock frequency for I2C communication. I2C slave devices have no minimum working clock frequency, however 100KHz is usually the baseline.ĬlockFrequency: the value (in Hertz) of desired communication clock. Reads a byte that was transmitted from a slave device to a master after a call to requestFrom() or was transmitted from a master to a slave. The number of bytes available for reading. This should be called on a master device after a call to requestFrom() or on a slave inside the onReceive() handler. Returns the number of bytes available for retrieval with read(). String: a string to send as a series of bytesīyte: write() will return the number of bytes written, though reading that number is optional Writes data from a slave device in response to a request from a master, or queues bytes for transmission from a master to slave device (in-between calls to beginTransmission() and endTransmission()). 1:data too long to fit in transmit buffer.false will send a restart, keeping the connection active.īyte, which indicates the status of the transmission: true will send a stop message, releasing the bus after transmission. The 7-bit address of the device to transmit to false will continually send a restart after the request, keeping the connection active.īyte : the number of bytes returned from the slave deviceīegin a transmission to the I2C slave device with the given address.

true will send a stop message after the request, releasing the bus. Wire.requestFrom(address, quantity, stop)Īddress: the 7-bit address of the device to request bytes from

Used by the master to request bytes from a slave device. There are no address only you can select scl gpio, sda gpio and frequency This should normally be called only once.Īddress: the 7-bit slave address (optional) if not specified, join the bus as a master. Initiate the Wire library and join the I2C bus as a master or slave.

Arduino wire library